Description

Product manual:

1. The probe is clamped on the spindle of the machine tool through the tool holder, slightly loosen the two opposite fastening screws at the bottom, and adjust the four symmetrical adjustment screws on the side to adjust the probe ball to coincide with the center of the spindle.

2. There is no need to rotate the main shaft when measuring the center, and the measuring head can be rotated 180° to make the measurement more accurate.

3. The probe supports measurement in three directions of X, Y, and Z. The reciprocating positioning accuracy is less than or equal to 0.01, the deflection range of X and Y is 0-6°, and the telescopic range of Z direction is 1mm. If the probe and probe are exceeded, the probe and probe will be damaged.

4. The probe has two built-in CR1616 3V lithium button batteries. When the power is insufficient, loosen the fastening screws and adjust the top wire, take off the top cover and replace it. When replacing, pay attention to the positive and negative poles of the battery, and re-adjust the center of the probe after replacement.

5. The side head does not support the detection of insulating materials and insulating machine bed

6. The probe supports dustproof and a small amount of dripping and waterproofing. Do not drip and wash for a long time.