Description

Product Description ：

01. Clamp the probe on the machine spindle through the tool holder and loosen it slightly.

Two set screws opposite the bottom allow adjustment of the four symmetrical adjustment tops on the sides.

The ball head of the line adjustment head coincides with the center of the spindle.

02. There is no need to rotate the spindle when measuring the alignment, and the probe can be rotated for the alignment measurement

Rotate 180° for more accurate measurement.

03. The probe supports X, Y, Z three directions measurement, with reciprocating positioning accuracy

≤0.01, X Y deflection range 0-6°, Z direction expansion range 1mm, more than

Leaving the safe area can damage the probe and the probe.

04. The probe has built-in two CR1616 3V lithium button batteries,

When insufficient, loosen the tightening screw to adjust the top line, remove the top cover and replace it.

When replacing, pay attention to the positive and negative poles of the battery, and re-adjust the probe center position after replacement

put.

05. The side machine head does not support the detection of insulating material and insulating bed.

06. The probe supports dust and a small amount of dripping and waterproof, do not drip for a long time

and scour.

Product display: