Description

DC motor forward and reverse remote control control panel push rod 12v 24V limit double delay relay module

Product size 89 ・ 82mm*49.784mm

The power consumption of the product is about 20ma, the low power consumption mode can be set, and the standby current is less than 10ma

Speed adjustment time: 0.01 seconds to 999 minutes can be adjusted arbitrarily

Speed range: 1-99 gears can be adjusted arbitrarily

feature of product

This product adopts the principle of H bridge circuit, with excellent performance, input and output optocoupler isolation, frequent switching at least 0.1 seconds, no noise, stepless speed regulation, far more than relay contact control, relay

It can control the forward and reverse rotation of the DC motor, speed regulation, timing, limit and other functions in one, to meet more application needs. There are demonstration operation wiring videos and paper manuals for customers' reference, and it is guaranteed that they will be used

Function setting description

P"l: Jog to signal 1, the motor rotates forward; signal 1 disappears to stop; to signal 2, the motor reverses; signal 2 disappears to stop;

P-2: Self-lock to signal 1, the motor rotates forward; keep forward rotation; give signal 2, the motor reverses; keep reverse; give signal 3, stop ie "3: give signal 1, the motor rotates forward for A seconds automatically Stop; give signal 2, the motor reverses to B seconds and automatically stop; give signal 3, emergency stop

P-4: Give signal 1, the motor is going to stop for A seconds or stop when it encounters the limit (signal 2);

Give signal 1 again, the motor reverses to B seconds to stop or stops when it encounters the limit (signal 3);

P-5: Give continuous signal 1, the motor is going to stop for A seconds or stop when it encounters the limit (signal 2);

When the signal 1 disappears, the motor reverses to B seconds to stop or stops when it encounters the limit (signal 3);

That is, "6: Give signal 1, the motor is going to stop for A seconds; after stopping for C seconds; keep stopping after reversing to B seconds [give signal 1 again, and execute it again; (if the signal is permanently short-circuited for this function; it can be No need to give Xinlu after power-on; the above functions are automatically executed)

P-7: Give signal 1, the motor rotates forward; encounter the limit (signal 2) and stop for A seconds and then encounter the limit (the signal leads to stop for B seconds and then rotate forward; infinite loop this (function if signal 1 is permanently short) connection; it can realize that there is no need to give a signal after the power is forced; the above functions are automatically executed)

P-& gives signal 1, forward rotation for A seconds, stop for C seconds, reverse rotation for B seconds, stop, forward rotation for A seconds... Infinite loop

(If signal 1 is permanently short-circuited for this function; it can be realized that no signal is required after power-on; the above functions are automatically performed)

"Power-on display" indicates entering the standby state;

Screen display: P-1: K2 and K3 adjustment mode Screen display ZF:

Press K1 for the first time, K1 for the second time, K1 for the third time, K1 for the fourth time, K1 for the fifth time,

The screen displays ZF:

The screen shows 7F:

show"

A001: K2 and K3 adjust the first time A,

B001: K2 and K3 adjust the second time B,

C001: K2 and K3 adjust the third time C,

"Indicates entering the standby state;

K4 adjust decimal point

K4 adjust decimal point

K4 adjust decimal point