Yamaichi IC Test & Burnin Socket with a simple board specifically designed for STM32 microcontroller in QFP100(0.5mm pitch) package

Features

20-pin JTAG/SWD port and/or 4-pin USART1 interface for programming/testing

External crystal can be connected via on board socket for system clock

Onboard 32.768K crystal oscillator

Two LED indicators for testing, which are connected to the I/O pins via jumpers

All the MCU pins are accessible on expansion connectors

pin header pitch: 2.54mm(100mil)

Supported Devices

STM32 microcontroller in QFP100(0.5mm pitch) package with compatible pinouts:

STM32L1xxV series (STM32L151VB, STM32L152VB, etc.)

STM32F1xxV series (STM32F103VE, STM32F100VE, etc.)

STM32F2xxV series (STM32F207VC, STM32F215VC, etc.)

STM32F3xxV series (STM32F303VC, STM32F373VB, etc.)

STM32F4xxV series (STM32F407VG, STM32F415VG, etc.)

Config the onboard "Device selection jumpers" according to the device to be programmed.

Outline and Dimensions

Unit: mm

Part Number

Pitch

Pins

Applicable IC Dimensions (REF.)

Outside Dimensions (REF.)

A x B

C x D

E

F

G x H

IC51-1004-809

0.5

100

14 × 14

16 × 16

15.3

-

39 × 39

Photos

JTAG/SWD port

for programming/debugging/testing

compatible with ST-LINK / J-LINK / ULINK2 / STX-RLINK

USART1 port

supports ISP and/or serial port debugging

LED indicators

for quick testing

Pin headers connected to MCU pins

clearly labeled with onboard marks

easy for testing and further expansion

Boot mode configuration

configuring the BOOT0 and BOOT1 via jumpers

3.3V onboard regulator

AMS1117-3.3

5V power input

DC jack or 2-pin header

External crystal socket

insert crystal to the holes on two sides, leave alone the middle hole

Power indicator

Device selection jumpers

short the upper headers for STM32L1xx / STM32F1xx / STM32F3xx

short the lower headers for STM32F2xx / STM32F4xx

LED jumpers

short the jumpers to connect LEDs to MCU I/O pins for testing

open the jumpers to disconnect

32.768K crystal (on bottom side)

for internal RTC with calibration

JTAG/SWD Connector Layout

The STM32-QFP100 houses JTAG/SWD headers for connecting a programmer. The connector layout is shown in the figure 1 below.

Boot Mode Configuration

Depending on the used pin configuration, the Flash memory, system memory or SRAM is selected as the boot space, as shown in Table 1 below.

Downloads

Development resources:schematic, etc.

Wiki: www.waveshare.com/wiki/STM32-QFP100

PACKAGE CONTENT

STM32-QFP100 × 1

USB power cable × 1